10Pcs RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer

10Pcs RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer

$9.89

Features:It using 22AWG wire, copper wire inside is very thick, can be resistant to current 2A, 300V voltage. An insulating layer over a wide range of temperatures, up to 80 degrees. Is the common con..

  • Ex Tax: $9.89
  • Product Code: 10xSKU161447
  • Availability: In Stock
This product has a minimum quantity of 10

Features:


It using 22AWG wire, copper wire inside is very thick, can be resistant to current 2A, 300V voltage. An insulating layer over a wide range of temperatures, up to 80 degrees. Is the common connection of thin copper wire can not match. Not easy to pull off, plug it convenient, for ease of use, plug the other side to do the one, you can use the direct plug
Board Size: Approx. 39 x 16 x 7mm / 1.54 x 0.63 x 0.28 inch
Cable Length: Approx. 70 cm / 27.56 inch


Connection Description:


Red line connecting VCC (ramps of +)
Connect the black wire GND (ramps of -)
Green Line connection SIGNAL (ramps in s)

Tips: Under normal circumstances, the system must be configured to at least three mechanical switches.


Package Included:


10 x 3D Printer Endstop Switch


                                           



Write a review

Note: HTML is not translated!
    Bad           Good